maddawg
+1y
Originally posted by bumlove_blue
I can mode that kit though can't I?
not the crossmember, but you can modify your stock one , and you can modify the motormounts if needed.or you can section your pan a bit, notch and raise you crossmember a bit.
tha ultimate crossmember will keep the front part of the frame(just below the front of the cab) about 3/4 off the ground.and what i didn't like about motor mount set up is that the engine sat very low (which is good in a sense)causeing my tranny pan to sit even lowwer.....too close to the ground for dragging comfortably.so i modified the stock front crossmember (notching it and raising it)and cut and raised my motor mounts to the correct pitch.there are other better ways of handling this situation but that what i did and it works great for me , now i can drag in peace without worring about putting a hole thru my trans pan.