99 up silverado

are arms or spindles required to lay one of these on some 20s? also, is it required to cut your fenders out?

if you use a 255/35-20 it it will lay frame on 20's with the inner fender wells still in....also stock arms and spindles work fine...these trucks are a piece of cake to bag

what about the rear? if i use the same size 20 in the rear, will i have to remove fenders and how much of my rearend will come through the bed? i still wanna be able to put my bike in this..

Same thing in the back, run a custom notch and you dont even have to cut into the bed.

check out my Silverado profile http://streetsourcemag.com/IM/viewusercontent.aspx?IMStyle=2&ID=kleerance

It layed out in the front with 2" lower control arms and just the bag. In order to drag I did have to pull the inner fenders out...Same thing in the rear, it had to be tubbed in order to drag. And just like Welch is saying...if you build a lower profile notch you could probably keep the stock bed floor.

Edited: 2/16/2006 4:06:49 PM by red02chevy

Here is a picture of my truck:it lays on the tranny crossmember with a 255/35 R20. I also have stock arms with Mcgaughy's spindles