Will this rear setup work??

ok, well i got bored and made up this lil drawing, i wanna make the lower bars out of 2*2 and the upper bars out of 2 old link bars that i had on my truck befor the 2 link. im not sure if this will work,but if someone has some ideas,just let me know... and its gonna be on a 1st gen s10

a href="http://tinypic.com">maybe this will work

I don't think so. It's not triangulated and doesnt look like your using a panhard bar to keep the rear centered otherwise.

Edited: 3/14/2006 2:22:48 PM by AftermathLongBed

u NEVER wanna use a 50/50(2 bars toward front, 2 toward rear) setup, it fucks with the pinion angle through the entire suspension travel

Edited: 3/14/2006 2:52:22 PM by draggin720

I RAN 50/50 SETUP DRIVEN DAILY FOR 3YRS WITH NO PROBLEMS & VERY LIL PINION CHANGE W/ A BAG OVER AXLE SETUP.

Originally posted by draggin720



Edited: 3/14/2006 2:52:22 PM by draggin720

I RAN 50/50 SETUP DRIVEN DAILY FOR 3YRS WITH NO PROBLEMS & VERY LIL PINION CHANGE W/ A BAG OVER AXLE SETUP.







drove daily for 2, then i got smart and redid mine. ur just a lucky one trust me

No, No and No again.

how bout this one. same in the rear just the front bars are straight

Edited: 3/15/2006 5:27:05 PM by Forever Draggin

i would do it like this, anyone see anything wrong wtih this?

like was said before dont run two forward and two reverse. they work against each other through out travel and throw the pinion angle off. run them all forward or all reversed. if you set it up rite you will have little to no pinion angle change wich ever way you decide to go.