krewzlo
+1y
You pretty much just enlarge your old shock hole to a little bit bigger than the cylinder and use a donut "larger washer" on the cylinder "slide it over the top and it will go down to the collar of the cylinder. Push the cylinder up from the bottom and there you go. The washer doesn't let the cylinder push through the frame. Put the cup on the shaft of the cylinder and put your coil underneath it and your done. Preferrably use a deep cup to help prevent the spring from shooting out.
fatheadjames
+1y
Originally posted by NaviGangsta
fuck all that
go solid mount on top, power ball on arm ... then run accumulators
The way to go for sure.
fuck all that
go solid mount on top, power ball on arm ... then run accumulators
The way to go for sure.
shortrodeo
+1y
Edited: 5/1/2006 9:45:42 AM by oOBounce22Oo
Heres a pic of when i broke my juice at Reso, but you can see the uper and lower mounts.. The upper is a pice fo 2x4 box, and when the juice has pressure in it the stroke sits up aganst the top plate. And Power balls are a little un-nessary on control arms, you can use a hyme joint if you want to.
And make sure your stroke has some wiggle room on the top mount else when you lift up and down the stroke might bind up.
Heres a pic of when i broke my juice at Reso, but you can see the uper and lower mounts.. The upper is a pice fo 2x4 box, and when the juice has pressure in it the stroke sits up aganst the top plate. And Power balls are a little un-nessary on control arms, you can use a hyme joint if you want to.
And make sure your stroke has some wiggle room on the top mount else when you lift up and down the stroke might bind up.