threads
Page 1 of 1
Mazda Trucks \  need a motor

need a motor

Mazda Trucks Make Specific
views 124
replies 9
following 8
 
dawgleggin   +1y
i would like a motor out of a 86 b2200 c it has alot less emission shi* than my 89 dawg? any motors out there
90maz   +1y
you don't need a 86 motor all you would need is the intake off a 86 motor but you can just pull most of the smog shit off with no change in preformance
dawgleggin   +1y
ok does anyone have an intake off of one then???
bdroppeddak   +1y
you mean 86 b2000 there were no 2200s yet. ive had an 86, 91, 93, and they all seemed to have the same octopus in the engine bay. the only solution is an aftermarket carb and header.
bdroppeddak   +1y
Originally posted by 90maz



you can just pull most of the smog shit off with no change in preformance

sure your preformance wont change but the performance will.

dssur   +1y
Originally posted by bdroppeddak



Originally posted by 90maz



you can just pull most of the smog shit off with no change in preformance

sure your preformance wont change but the performance will.



cris (bdroppedspellingcop)
90maz   +1y
sorry sorry i fucked up typing i pulled all that shit off mine and it's still runing good at 360'000 mile's with stock carb, stock intake, stock cam, pacesetter long tube header 2 1/4 pipe no cat and a 2 camber flowmaster dumped all i've done to it was a dirty rebuild at 270,000 mile's
idragsdaily   +1y
Edited: 7/13/2006 7:21:23 PM by idragsdaily

yeh i have an 86 b2000 engine and 5speed tranny for sale for the low low. its used but it ran when i took it out has a new clutch kit in it. took it out to do a 302 swap. need to sell ASAP for money to do swap . hit me back at endlesskustoms@netscape.com
madlowmazda   +1y
Kia sportage 16 v dohc efi, or fuel injection set up off a newer b2200.
phxfun   +1y
I have a complete drivetrain ot of mine. 20000 miles since rebuild after 210,000. I have all of it removed as I am putting in a Buick V6. Make me an offer. Everything is out f it on a stand and in boxes. Ran great when I pulled it out. I powdercoated the intake manifold. Made an emmisions blockoff prior to removing it. I also have a weber on it hat I never used. Put it on, started it up, and then removed the engine. Make me an offer.
Page 1 of 1