i need a core support

Anthony,
I just put the core support up on fbirides.com- $99.95 retail, and if you know somebody with a Club card, it's only $54.95! It's Oversize x1 through UPS, so figure on about $25 for shipping.

-Phil at FBI

Originally posted by framelayer521



Seth,Bring your bed up here so I can get a clean pattern!

-Phil at FBI

Next show is the Halloween show right? In October? I might frame the bed so I can bring it then. Its got a stock pan thats got some reflectors and a license plate recess, thats all I want to remove. Rather than shaving it? Do you need the pan too? Or shoudl I just cut that off.

Sorry to whore on your thread Anthony.

I had a '79 a few years ago that was just too beat up to get a good pattern from. If your stock pan is still on there, that's OK with me. Hell, I trust your abilities- just trace the pattern on something, grab a width top and bottom, and swing it up here- we can build a prototype off that and fine-tune it when you install it. Let me know!

Anthony- I made up for jacking your thread by emailing you a special deal on that core- let me know!

-Phil at FBI

phil its cool your helping out seth so i dont care and thanx for the email ill also probably be ordering a rear combo with leds next week so ill pick it up then i got to wait for my next check