Datsun 620

Edited: 7/10/2006 2:11:29 PM by SinicalOutkast

i hope i posted this in the correct section, if not then my apologies. i'm going to check out a '72 Datsun 620 and I wanted to get some info on what's involved in bagging these trucks. is there anything special that needs to be done up front? what would the best setup be for the rear? also, are there any custom wheels that can bolt right up? thanks for the help, i appreciate it.

the 620 are damn near the same as the hardbodys. its torsion up fron and leaf in the rear

bttt

Not sure if there is such thing as a 72 620, but yeah, cut the torsions out and check this thread http://nwde.org/extras/forum/forum_posts.asp?TID=2932&KW=culowdragger72
especially!

Lates

datsun 620's were produced from 1972-1979