integraoligist
+1y
I finished up my fronts and started working on the rear...
I jack up the back and first attempt to take out the bolt holding the (upside down Y) from the wheel assembly so that I can just take the 2 top bolts out of the hatch and remove the entire thing.
But hell no, fucking bolt on the Y breaks and i CAN NOT get it out... i try using an air hammer to whack it through but it's not moving. So i went to the other side of the car and attempted it again. FUCKER BREAKS TOO! AHHHHHH
I can't find my damn grinder anywhere, i just want to saw this whole fucking thing off but NOOOOO.
So, any ideas on how the hell to take these fucking bolts out please?----yeah, i found my grinder and cutoff the "welded on" nut... then I started whacking both sides of the bolt, basterd wont move.... got my air hammer, that did'nt even budge the basterd.
Anyone else with a Teg have this problem and if so, what did you do?
Thanks all!