square d press. switch

i did not get any directions with mine an suicidedoors is closed today anyone know how to hook it up?

go to their website there is a link with a diagram there. under air management i believe.

maybe this will help

that doesnt show the wiring for the square d, just a 2 wire ps.

Check out my wiring diagrams at http://www.airridetalk.com/wiring-info/

oh my bad.

yeah the Square D doesnt need an external relay. i belive there is a diagram at www.bagginit.com

if you are running any type of unit that runs at a high amperage, you need a relay. I.E. multiple compressors or a single high current draw compressor.

and that square D switch can handle a good amount of amperage. if you want to run no relay, just make sure the switch you get is rated for the amperage you're putting through it.

all square d's come with directions, its a little folder up piece of paper inside the housing, and i think the sticker inside the cap has it too..either way, that switch has two curcuits, and you only use one for each comp. theres a plastic divider in the middle of the four terminals, you only use two terminals on each side, you dont jump across it. then just hook it up like any other p/s.

http://www.airridetalk.com/images/stories/wiring/1_1_1.gif in this picture only one side is hooked up i have 2 compr. do i only need to hook them up to one side ? what if i fused the switch an just ran it straight to the batt instead of jus running it to the ign wire..