24s with 295/30 in the front 88-98 ?

what all problems am i going to occur? has anyone done it ? what has to go ? what has to be cut ?

Even with the correct backspace (7.25" on a 10" wide wheel), you're going to get into quite a bit of work.

Mine will get down on that sized tire of 30.96", infact, it'll even get down on a 31.22" tall tire (285/50/20).

I can't tell you much about the heater core/lines or the wire harnesses because mine have all been removed, but you will need to tub the ever loving crap out of the firewall, notch and fill the frame for the tie rods, notch and fill the frame or Aarms for clearance, use spindles, possibly cut/reposition the ball joints on the Aarms (depends on what you're using), I'd go for the hydroboost brake setup..... hah, I'm running a 7" dual diaphram with a low-vac camshaft- not smart. I have tons of photos, just email at Jody@sportruck.com .













GMC is for sale. $8500 or best offer.

Talk to mccustomize. I saw he put 24's on all corners or his ext cab fullsize. I believe he did all the work himself so he should be able to answer any questions you have. Good luck and post pics when you get some.

im in the midle of doing my suburban on 305 35 24s or maybe 305 30 26 i dont know yet i dont have the wheels yet but leaving room for it and you have to reangle you ball joints and cut almost every thing this isnt my truck but i went by this its a suburban on 24s its on here too just look for it http://www.fullsizechevy.com/forums/showthread.php?p=2328637#post2328637

jody i saw your truck at winni stock that thing is nice where did you get your arms

Modified AIM units I've had since 1999 or 2000 or so.

Yeah, had it for sale on the trailer at that show- or whatever it was. Hell I live 10minutes from the race track in Sealy.

It's still for sale. No takers.

Here is mine with a 275/45/20 which is 29.7" tall. With another inch of tire it would be close, but I think it would be possible to lay and still have the tire under the hood.

why not roll 18"s?

can any post some fabbed pics of the balljoint repostions.

just z the frame, mine lays body on 22's with uncut arms and stock spindles, lays on 305/35R24's with drop spindles