Mazda wheels

Anybody Know If newer titan 6 lug 18 in wheels will fit on an 89 b2200???

if you have 4x4 sheetmetal, or pull your rear fenders waaaaayyyy out. They are 18x8 with +31 offset, they will stick out past the back fender edges about a half inch. the front will tuck because of camber, but not if you have drop spindles.

They're 18x8 with +25 offset, Russ. I 'fitted' one on the rear of my truck just to see how bad it was, and it barely tucked into the fender on my 2wd bed and I have the fender edge folded up. Even then it only tucked up about 1/2", lol.

even worse, thanks for the correction, I was thinking of another wheel

Yea, the 17x7.5" Denalis and Escalades are the +31mm ones

So what all needs to be done to make these wheels fit??

either flare your bedside out by 6mm all the way up on both sides or shorten your axle by 6mm on both sides.

either way is a lot of work and it would be easier to find wheels that actually fit.

Had the same problem with my 18" Infinity QX56 I had to flare the bedsides out quite a bit to get these things to tuck, and even then it was still close! Just be carefull, and make sure you clear the rim lifted and dropped!

Here is a link to the Mini Truckin tech article on how to flare b-series bedsides w/o screwing them up!


http://www.minitruckinweb.com/tech/body/0309mt_fender_flare_tech_how_to/

Good luck!


Devon

I have 2 '04 chrome navi wheels for sale with 225/35R18's that someone should buy from me

What do you want for your navi wheels?