how much to do stock floor a taco???

Whats up,.....what does it cost (on average) to perform a stock floor body drop on 18's?

What do the materials run?

What materials are needed?(other than 2x3 square tubing)

What's the difficulty level? (do alot of people fuck these things up?)

And finally: what's the most difficult part?(usually)

Thanks for any help or advise, "Lost Cause"

nothing is hard, it just takes time.

i would say 3500 would be a good deal for a stock floor, you are probably lokoin at around 5 grand from any inflated shop.

Edited: 12/11/2007 3:55:35 PM by Retro83

measure 2xxx cut once!

Im starting mine this comming monday and just spent about $250 on metal. I got about $2000 into the suspension components though. Im sure as the project progresses I'll be up in the $3000 range though.

we do them starting for 2500 give or take depending on what your looking for as far as how crazy u wanna get with tube work and such...

As far as difficulty level not for everyone to do but its not really brain surgery,just alot of math and angles.. but it is a ton of work...

Edited: 12/11/2007 4:09:10 PM by lost cause

what are the chances of finding somone to do some trade work with?Would any one be interested in trading for the paint job of there dreams? if only my fab skills were half as good as my paint skills)...lOL "Lost Cause"

to bad you arent in v ville anymore, i may have been interested.

Sent you a PM!!!

Sent you an IM TuKnRail^^^^^^Originally posted by NO1LOWR



to bad you arent in v ville anymore, i may have been interested.

Shit,....I wish! You do some awesome work! I going to have you make me a sig too ( I love yours) "lost Cause"

Edited: 12/11/2007 9:04:11 PM by lost cause

Edited: 12/11/2007 9:03:51 PM by lost cause

Anyone else intersted in trade work?I'll throw down a pimp-ass paint job for a stbd.......... "Lost Cause"

BUMP,.....come on now. I know there's some great fab-master+ Out there looking to do some trade'n "Lost Cause"