threads
Page 3 of 16
Full Size Truckin General \  The Story So Far...baggin' an 87

The Story So Far...baggin' an 87

Full Size Truckin General General Discussions
views 3684
replies 151
following 73
 
bodydropped85   +1y
thats fucking badass! is it gona lay rockers?
tealchevy   +1y
no rockers. laying frame....but flat front to back. The pinch will be an inch off the ground
okcderek   +1y
I been checking out some of your work on DFWmini..........you do bad ass work. Thats a really clean Z you did to this truck...
pasomike   +1y
did they have to adjust the motor or trans when they z'd the frame? im thinkin of doin mine but wanna find out wat all i have to do first
tealchevy   +1y
Just for clarification....I didnt do the metalwork. All of the metalwork was done by Keith at Nfamus Air Suspension in Mansfield
tealchevy   +1y
oh, and that last picture is WITHOUT drop spindles
LndRanger86   +1y
SO THE TRUCK WILL LAY FULL FRAME WITH JUST THE Z DONE? AND IT WILL ONLY LAY ABOUT 1" OFF THE PINCH? WHAT ELSE IS INVOLVED?
tealchevy   +1y
pulled both tanks, new transmission crossmember, and the Z'ing of the front crossmember. Those are all the things that hang below the true frame.
LndRanger86   +1y
THANKS
tealchevy   +1y
ill have the truck back in my possession soon, so I can answer a lot more questions then
Page 3 of 16