If someone doesn't mind....

If anyone would do this for me I would very much appreciate it...I have installed 2 new O2 sensors, but I'm still pulling codes on them. Resetting the ECU did nothing so I have to assume there is still a problem. I tested them on vehicle and pulled some weird readings from the upstream sensor. The rear one seamed fine, but to be sure I'm hoping someone wouldn't mind taking a look at their wiring from before the plug and give me a listing of what color the wire is and to what color wire it connects to. It looks to me that the rear sensor is wired wrong, but it reads right. I just don't know anymore. Thanks for anyone that does it for me, Merry Christmas guys!

1st we need to know what kind of vehicle. What motor and year too

Ya, sh*t...forgot that part. 93' Yota P/U 2wd 22RE 4 cyl. manual trans.

i would do it for ya but i didnt do any of the wiring or the motor work on my truck so i have notta clue what were talkin bout here. theres a lot of sensors and wirning on these damn things.

There are 2 O2 sensors on the exhaust piping under the cab of the truck. If you can see them, I just need the wiring layout. Thanks man

my 92' 22re only has 1 o2.

Weird. Anyone have an AllDATA schematic on their computer they could post on here?

yea if i was still in school i could tell ya bout that... i dont use o2 sensors on my dime dont need them....

Nevermind, I found my AllDATA schematics on my laptop. I'll update if I figure this dam* thing out.