s10 ppl i need some help!!!

ok well im starting on the stockfloor on my girlfriends truck and have a couple of ?'s. first off we just doin under the cab keepin stock frame due to her already havin the thorebeck 3 link. what size tube everyone been running i have some 2x2 1/4"wall and 2x3 1/4"wall and does anyone have pics of how they did their's? this is my first s10 ive done so i know these are stupid ?'s for most ppl so dont be to harsh on me.

GO ON IFCUSTOMS WEBSITE THEY HAVE GOOD PICS OF HOW THEY DO THERE FULLSIZE TRUCKS

for the jis.. cut the stock cab mounts and lower then the desiginated bd amount. mark up 2.75 from the bottom of the stock frame upward, then cut at that line till just after the firewall.. stick the 2x3 in the frame and it gives you a nice spot to weld the stocker to the new 2x3. from there i am sure you can figure it out.

hey give me some time and i will get ya the pics from were i did mine.use the 2x3 for the frame and u can use the 2x2 for the crossmembers. but i will give you more detail when i can get my pics off of one computer to put on this one.s10dragn - Photobucket - Video and Image Hosting there is a few pics in my photo bucket so fell free to check it out. send me an email back so i dont forget cause i been busy trying to get that thing back on the road along with my daily car. lol yeah it sucks both are down at the same time.

thanks helps me out alot guys now i can get to cuttin and make her happy

oh and how much do most ppl usually bodydrop a dime? just flat rocker

depends.. 2nd gen its 3" to lay rocker hard (its 2.75 to touch the very bottom of the rocker)

1st gen is 3.5 to hard rocker.

it was 2 3/4 to rocker for mine

yeah 2.75 for where the rocker meats at the bottom.. but to have that folder under (flat) looking lay, its 3.. some ppl want the latter.