brake booster for d21 hardbody?

what is the best option to change or remount my booster so i can lay on 18"

you can lay frame on a 20" with out hitting your booster so framed or even bodydropped on 18s you shouldnt have any problems

no the tyre is definatly hitting the booster and holding to vehicle up 3"

how much body drop do you have?

if im correct im pretty sure this is an aussie truck. our brake boosters over here are on the right hand side and they do hit the tyre when layed out. if ya keen dude you could always do a full disk brake conversion and just not run a booster. dude running sr20s and ca18 turbos in little dato utes are pulling up ok with them. if not i think you can make a early model celica booster fit onto your cylinder. dont fully quote me on this as i have herd it from other people and not tested the theory yet.

Edited: 5/17/2008 6:57:19 AM by P

they hit on american trucks too

here is what i did.. i cut out the square that my booster goes into, plus like 1.5 inches to the left of the booster.. then i just simply flipped the piece around, so that 1.5 extra material was now next to the clutch slave.

here is a picture of mine.. in the pic is my old 205/40/17's.. i have 225/40/18's on it now which are 25.50 tall.

www.finalfab.com