bagging a square dually

has anyone bagged their square dually with out doing a Z and a stock floor drop? how low does it go and does it lay out?

Whats up man ? Trucks looking killer ! Well,over the years from what ive seen,read and heard, 9.999 out of 10 squares need a Z to completley out,without arms touchin.but,ive seen a few that didnt require a z...you have options to aid you such as drop spindles,cupping arms,plating arms,aftermarket arms ect..any more questions,ask away..im in process of baggin mine as we speak,so ill share what i can..hope this is a start

i want to bag mine but not sure if im down for chopping it up :S i would be happy with it just laying down even if its on the control arms not too worried about it laying pinch weld.

Thats piece of cake man....

i like the sounds of that

Mine is getting done as we speak. Ill let ya know the outcome. We are doing the drop spindles up front and then cupping the uppers. The rear is a complete 4 link suspension c notch and all. Ill post up more pics should be done by end of next week

Yup...so what ur plans for the rear

I don't want anything sticking through the bed if possible. not sure on the set up tho.

that would be awsome if you could!

My 87 square laid out without 'Z' ing the frame. But i had to install 2.75 inch cups in my lower control arms. And it layed frame. But it was still not low enough so i went ahead and body dropped it. As for the bed, i still had to cut a hole for the notch. Hopefully this helps some. Good luck