pmiller
+1y
How far is Columbus MS to your shop? My father was born in Columbus. You do some great work! Is business pretty steady for you?
KEEF
+1y
its about 2 hours or so and yes buisiness is busy but not from this area at all. Most of our work is out of state.
KEEF
+1y
Originally posted by dragndime
emailed ya keef
Did u send it to john@keefsrodncustom.com ??? I havent gotten it
emailed ya keef
Did u send it to john@keefsrodncustom.com ??? I havent gotten it
KEEF
+1y
Baxter finished up bodywork on the bed this evening and got it in the booth for primer. I fabbed inner panel using 14 gauge sheetmetal and a ranger tailgate inner plate. Also using the handle section out of ranger gate welded into inner panel so we can use a ranger tailgate handle.
KEEF
+1y
Edited: 2/2/2010 9:14:28 PM by KEEF
Inner panel is fully welded and being bodyworked, handle/access panel is fabbed and in primerWe got the bed in primer last week and got it all blocked with 180 then touched up a few spots with 2part putty then reprimed with 2k urethane Its ready to spray inside then final blocked and spray exterior now
Inner panel is fully welded and being bodyworked, handle/access panel is fabbed and in primerWe got the bed in primer last week and got it all blocked with 180 then touched up a few spots with 2part putty then reprimed with 2k urethane Its ready to spray inside then final blocked and spray exterior now
jmzcustomz (jeff)
+1y
Damn man. I wish I had the money to drag my shit 45min up the road to you to handle. The black looks so clean and wet!