Page 3 of 7
Nissan Trucks \ Innovative Customs Titan(rebuild hack job)Innovative Customs Titan(rebuild hack job)
views 3493
replies 68
following 33
FoolInjected
+1y
There are still 2 sets of bars to be added and 1 set comes off that bar,also the bed is being completely reskinned so it will fit the contour of the last hoop .
There are still 2 sets of bars to be added and 1 set comes off that bar,also the bed is being completely reskinned so it will fit the contour of the last hoop .
bdmpastx
+1y
Looks like everything I said in the past about the previous install came to a head. It looks like it is going a lot better now though. The rear is the easy part. It is the front where all sorts of issues arise. But I am sure they will figure it all out.
Looks like everything I said in the past about the previous install came to a head. It looks like it is going a lot better now though. The rear is the easy part. It is the front where all sorts of issues arise. But I am sure they will figure it all out.
FoolInjected
+1y
The front is complete all but running hd lines they retubbed firewall both sides (no more rubbing when turning deep).Im still running bio maxx's spindles with prg uniball control arms and still laying out on 26's
The front is complete all but running hd lines they retubbed firewall both sides (no more rubbing when turning deep).Im still running bio maxx's spindles with prg uniball control arms and still laying out on 26's
FoolInjected
+1y
Edited: 7/23/2009 9:38:58 PM by FoolInjected
Nope they are still the same uppers,they are done designing the rear section they just have to finish weld and then on to makeing fuel cell and then the bed.
Nope they are still the same uppers,they are done designing the rear section they just have to finish weld and then on to makeing fuel cell and then the bed.