Page 8 of 12
Build-Ups \ Tre5 Customs...stock floor, IRS, and hydroholicsTre5 Customs...stock floor, IRS, and hydroholics
views 4564
replies 119
following 57
jetts
+1y
love the simple clean bridge tube work. Jeremy is doing an amazing job and will be building my next ride (whenever the hell that is) the truck looks bigger in real life, the smashed pictures and the fact that nothing is really mounted on the pictures.. throws it off, i think its going to be sick!
love the simple clean bridge tube work. Jeremy is doing an amazing job and will be building my next ride (whenever the hell that is) the truck looks bigger in real life, the smashed pictures and the fact that nothing is really mounted on the pictures.. throws it off, i think its going to be sick!
tre5
+1y
---------------------------------------------Originally posted by lowrthnu92Arent spindles forged ?---------------------------------------------no, they are cast.
str8azztaco
+1y
Good idea on the rear bars on the irs. What are you doin with your clutch setup, and you plannin on keepin the ac? I'm about at the same stages with my sfbd,reg cab,with the same rx7 irs
Good idea on the rear bars on the irs. What are you doin with your clutch setup, and you plannin on keepin the ac? I'm about at the same stages with my sfbd,reg cab,with the same rx7 irs
tre5
+1y
Got the core support and fenders on. I adjusted the cylinders to hold the truck up about 1/4" because the tire pushes the fender out when it is all the way down. The wheels need to have some meat taken off of them, then it should be fine to lay the truck all the way down. Also got the rear end done and painted.
