Page 8 of 18
Build-Ups \ 1st gen crew cab bd with 87 grand national drivetrain GPC1st gen crew cab bd with 87 grand national drivetrain GPC
views 11180
replies 170
following 56
onelowrov
+1y
i appreciate the comliments. been messin w it for the past 3 weeks on the tranny n drive shaft tunnel, shortening the art control arms elec fans, brake booster, rad hoses(lower passes through the frame), etc..... This week will be startin on the firewall tubs and exhaust. havent put new pics up of recent progress cause i dont think theyd be that interesting. but will be puttin some up of upcomming progress soon. talk to u soon.thanx again. mike
onelowrov
+1y
Edited: 1/12/2011 11:44:43 PM by rov
Edited: 1/12/2011 11:41:51 PM by rov
been workin on it for a bout a month now. got the blazer rear bumper tucked nice n tight to the bed, modified and mounted the grand national center council and shifter n put in the gn steerin wheel to, hand made the cold air intake, exhaust, turbo down pipe, and cross over pipe, n lenghtened pass header, ran the upper n lower radiator hose (n yes it goes through the frame), put on shorter oil filter to clear frame, raised tranny tunnel a bit, shortened control arms, installed 400 degree high temp material around exhaust where it passes through the frame for a hangerless exhaust, mounted power steering resevoir n ran lines, installed dual 12 inch fans, 7 inch booster and master,mini starter, and a bunch of other little crap. bout to tub firewall then will disasemble paint floorboards and rollin chasis reassemble n start doing the wiring, brake/fuel lines install air ride components and hopefully itll be runnin sooner then later. once that comes then ill finish rear doors then bed. by then summer will probaly be half over. ill try to put up some more pics as progress happens. talk to ya soon. mike
Edited: 1/12/2011 11:41:51 PM by rov
been workin on it for a bout a month now. got the blazer rear bumper tucked nice n tight to the bed, modified and mounted the grand national center council and shifter n put in the gn steerin wheel to, hand made the cold air intake, exhaust, turbo down pipe, and cross over pipe, n lenghtened pass header, ran the upper n lower radiator hose (n yes it goes through the frame), put on shorter oil filter to clear frame, raised tranny tunnel a bit, shortened control arms, installed 400 degree high temp material around exhaust where it passes through the frame for a hangerless exhaust, mounted power steering resevoir n ran lines, installed dual 12 inch fans, 7 inch booster and master,mini starter, and a bunch of other little crap. bout to tub firewall then will disasemble paint floorboards and rollin chasis reassemble n start doing the wiring, brake/fuel lines install air ride components and hopefully itll be runnin sooner then later. once that comes then ill finish rear doors then bed. by then summer will probaly be half over. ill try to put up some more pics as progress happens. talk to ya soon. mike
