My dime back half build up done at LBC

Low Budget Customs
 
the back half were redoing on my truck dont have pic of what it was but i will tell you  rev 4 link bags over axle little bridge so so build not to nice
 
 
 

 
 
 

 

 

 


 

 

 

 
not finished yet but thats all the pic i have of it right now  post more soon

are you gonna have room to run a watts link or pan hard bar cuz it looks tight

ya its parallel 4 link with a watts link

I hope there is bracing under that fuel tank, if not those tabs won't last long.

those bags should be solid mounted to the canti IMO

---------------------------------------------Originally posted by DOOREDI hope there is bracing under that fuel tank, if not those tabs won't last long.---------------------------------------------

there is its setup to drop from the bottom easy acces.

something ive never seen before on a canti set-up. whats the lift ratio on the bags? looks like if they fully inflate (8") the lift would be like 20+". definately watching the build

hell yea boomer hurry up and finish it before our show

Any more bracing going on that crossmember? It may as well be non existent if its just going to be that piece of flat plate over the driveshaft.

that bag looks if it lifts its gonna roll over like that other canti lift pics where the bag folded over