Build : 03 Ram SFBD on 24's & 26's

thanks!

Edited: 4/11/2010 5:19:16 PM by Chopped Mazda

Got the watts link mocked up and in place.  Still need to weld it all.   Taylor

Looking great! love the welds they look very good.

thats a great looking back half  and canti set up...  may ask how much lift you are going to get out of that thing...  or what ratio it is set up on?  Love the lower profile look...  most canti set ups look gody... this looks racecar inspired....  me likey.... 

Thanks guys  The cantilever itself is setup as a 2:1 ratio.  But the point that the cantilever pushes down on the link bar also is ahead of the axle, so it adds to the ratio a bit. Anyways, it will beable to get about 12" of lift, but how the rear shocks will be set up will limit its lift just a little.  Taylor

speechless

I hope thats a good speechless haha.   Taylor

work looks great, I just got the same welder, should be here Wed. Love the canti setup too

damn looks great taylor!

Thats a great speechless man. Like the other man said, the canti looks race inspired. What is that some sort of E coat on the frame tubing?. Better make one of your famous ram tanks for this build as well!. Cant wait to get mine .  Nice Tig and Mig tho!, just bout a sp175-t my self. Stupid question tho.... Is that frame mandrel bent or hydo formed?. I cant see square tubing bending without crushing at all, proly b.c I have never seen it done tho lol.