Page 18 of 23
Build-Ups \ first official Tre5 Customs build. 98 FSCfirst official Tre5 Customs build. 98 FSC
views 7882
replies 223
following 72
AON-4PumpedCL
+1y
Certainly looks amazing. Can't wait to see everything together and the chome all shined up. Each job just gets better!
Certainly looks amazing. Can't wait to see everything together and the chome all shined up. Each job just gets better!
mjavy7
+1y
---------------------------------------------Originally posted by tre5More progress... Pictured is about 2" short of full lift, so plenty of lift!.....---------------------------------------------Right... so what hapened not enough air preasure? LOLJust kidding....But seriously that is some mad lift, what was stoping it from going higher?
---------------------------------------------Originally posted by tre5More progress... Pictured is about 2" short of full lift, so plenty of lift!.....---------------------------------------------Right... so what hapened not enough air preasure? LOLJust kidding....But seriously that is some mad lift, what was stoping it from going higher?
AON-4PumpedCL
+1y
---------------------------------------------Originally posted by MJAVY7---------------------------------------------Originally posted by tre5More progress... Pictured is about 2" short of full lift, so plenty of lift!.....---------------------------------------------Right... so what hapened not enough air preasure? LOLJust kidding....But seriously that is some mad lift, what was stoping it from going higher? ---------------------------------------------To speak on Jeremy's behalf, the hydraulics aren't actually installed yet, so he just have a spacer over the stroke of the cyilnder. Once the setup is installed it will obtain full lift, no problem.
---------------------------------------------Originally posted by MJAVY7---------------------------------------------Originally posted by tre5More progress... Pictured is about 2" short of full lift, so plenty of lift!.....---------------------------------------------Right... so what hapened not enough air preasure? LOLJust kidding....But seriously that is some mad lift, what was stoping it from going higher? ---------------------------------------------To speak on Jeremy's behalf, the hydraulics aren't actually installed yet, so he just have a spacer over the stroke of the cyilnder. Once the setup is installed it will obtain full lift, no problem.
tre5
+1y
Aaron has it. I cut some spacers to slide over the ram of the cylinder to hold it up. It had to go to the shop to get the exhaust and stuff done, so that held it up to get on the trailer. I cut the spacers about an inch short, so it should lift at least another inch, but probably more like 2 inches due to the placement of the cylinder on the lower arm.
Aaron has it. I cut some spacers to slide over the ram of the cylinder to hold it up. It had to go to the shop to get the exhaust and stuff done, so that held it up to get on the trailer. I cut the spacers about an inch short, so it should lift at least another inch, but probably more like 2 inches due to the placement of the cylinder on the lower arm.
purpl7duece
+1y
All I can think of when I look at the inner bed is Pac-Man. Came out pretty sweet Jeremy!
AON-OFFDAHOOK
+1y
Are the accumulators going to be higher than the bed rails? Even if so...that doesn't bother me in which it remind others around it that it's juiced. This has quickly turned into one of my favorite vehicles - Jeremy you outdid yourself this time, looks insane.
Are the accumulators going to be higher than the bed rails? Even if so...that doesn't bother me in which it remind others around it that it's juiced. This has quickly turned into one of my favorite vehicles - Jeremy you outdid yourself this time, looks insane.