stock floor s10blazer

whats the eastiest way and fastest way to stockfloor one. its gona be on 16inch smoothies

Why not just do it the right way no matter how long it takes?... I have never understood why people have hacked up set ups and when you are looking at it at a show they always say something like "we did it in 3 days to make it to this show". Why not take the extra time to do it right and bring it out a few shows later. Just my thought.

Sorry man, but there is no easy way to do those.Take your time and a lot of measurements, and it will pay off in the end.

take it to a pro and pay them a few xtra grand to get it done quicker

You wont enjoy that as much as putting your own blood sweet and tears into it!!!

USE A 80 AMP FLUX CORE WELDER....J/K...the easiest way would be a traditional.or if you insist on sf get a frame table take your time dont rush..the "easy" ways usually end up fucking you in the long run and cost 3 times as much in the end..

yeah iam gona take my time time, just lookin for the  most simplest way to do. i have seen people cut out right under the cab and put some 2x2 i guess in there and do it like that