Page 14 of 31
Build-Ups \ "this may take a while" Tre5 Customs 72 Blazer Roadster"this may take a while" Tre5 Customs 72 Blazer Roadster
views 18137
replies 301
following 113
2LOW4U
+1y
--------------------------------------------
layed98yota said:
so after the flash and they do the harness it plug and play? were is this company located? thanks for the help jeremy
--------------------------------------------
I posted his info and phone # in your thread the other day.
layed98yota said:
so after the flash and they do the harness it plug and play? were is this company located? thanks for the help jeremy
--------------------------------------------
I posted his info and phone # in your thread the other day.
tre5
+1y
Got the Grant Customs skin welded up and installed the 15" AVS led tail lights installed. My buddy Will came over and helped out a bit. I had to get a picture of someone other than me working on the truck, so here he is... drilled who knows how many holes in the floor piece.
tre5
+1y
Almost done with the tranny hump. Just one small patch panel on the drivers side to finish up.
AZ ARTWORX
+1y
tranny tunnel looks good goes well with the truck way better than a rolled one id say
tre5
+1y
ok, finally back to work on the blazer. I got the 1" narrower Porterbuilt arms on and the hood now closes.
The standard arms from them were a bit too wide for the 24's to fit under the hood. With them now 1" narrower the tires clear the roll in the hood. So I now have the chrome ones for sale. I am asking $1000 for them. They have obviously been used, but only for mock up and never driven on. $1000 is what they sell for brand new and I have $300 into chroming them. So basically free chrome for the buyer.
I also got the Porterbuilt hood hinges on and all the front end mounted up. Now I just need to add some support in the fenders as well as a place to hide wires up underneath the fender support. Then weld up the front Grant Customs roll pan and fill all the little holes in the hood, grill, and fenders.
The standard arms from them were a bit too wide for the 24's to fit under the hood. With them now 1" narrower the tires clear the roll in the hood. So I now have the chrome ones for sale. I am asking $1000 for them. They have obviously been used, but only for mock up and never driven on. $1000 is what they sell for brand new and I have $300 into chroming them. So basically free chrome for the buyer.
I also got the Porterbuilt hood hinges on and all the front end mounted up. Now I just need to add some support in the fenders as well as a place to hide wires up underneath the fender support. Then weld up the front Grant Customs roll pan and fill all the little holes in the hood, grill, and fenders.