Ok I have had my front bagged for a few months now and everything has been great. I have water traps, check valves, a water drain on my tank, everything needed to run my setup just right. I started having slow leaks through my 1/4" dump valve in the right front. If I lifted it up and then dropped it hard it would stop but only after I did this a few times. That happened on Thursday and Friday. Friday night I went to lift my truck and the right front dump valve stuck at full open. We tried everything to get it to close but it just stayed open. So I let my compressors fill up all the way and then hit the lift and lower switches very quickly several times and it finally closed. No
www...it dumps like I have a very small reducer on it, the driverside drops faster than the passenger side. I bought these from Suicide Doors a few months back, should I hit them up to see if they will send a new one or hit up whoever the manufacturer is? I haven't pulled it off to see if anything is in it because the way it has been acting just doesn't make any sense. If I need to pull it apart and clean it then ok, but like I said, it has only been installed for a few months and I have water traps that I drain religously. What do you guys think? Anyone else have these problems with SMC valves?