More progress ....getting closer.(UPDATED)

lookin good bro

Yeah, panhard bar is weird looking cause I wanted to keep my bed floor as close to stock as possible...so he mounted the bags low and behind the axel and needed a place for the panhard bar to go. Was originally goin to go w/ a Watts link but just not enough room for everything, especially w/ all the stuff I wanted...didnt want a huge notch cover, didnt want to raise bed floor, didnt want to move gas tank out of stock location...I was pretty picky about where I wanted everything.

...gas tank gets pretty close, but I think we are going to raise it some.

Cool Man. Looks good. I like how everything is mounted under the bed...shows some thought.

hey guys,i have a ?? on this setup here,by the way name is jason new to the site!but i just rebuilt an s10 that was set up with juice,had the cylinders mountend on the rear of the axel.and it had alot of stress and twisting,on the rearend,do you have the same thing?cause this dime was horrible literally ate u joints!

No problems so far......the setup as far as bag mounts, is basically how Air Ride Technologies sets up the dually kit if you buy it from them.( bags behind axel like that.)

the bags behind the axle will carry more but in a high lift setup they will cause large pinion change.

right on thanks guys.the set up looks good,i was just wondering,cause the juice set up i had to rebuild was like that and it was so shitty.