Free Set of Tubular Control Arms - Details inside!

$949.99 a set 2-uppers(balljoint) + 2 lowers(balljoint) + two upper bag plates. Comes with the crossshafts(upper and lower) balljoints ect...

heres the link:

Richie

hmmmm nice website not a lot of suspensionparts on there though .
how mush would a watslink for a narrow 14 bolt go

thanks man, i know there is about 25% or less of what we sell on the site, i am the one that works on the site and i have just not had much time to add every thing. I try to keep the main parts upto date as much as possiable.

As for the prices on the watts i was going to try to get all those figured out this weekend. Do you want it raw? give me a call at the shop 989 671 3729 when you get a few mins and i can get you an idea of what you will have into it. Do you want the same style as i am using? i fucking love my watts, i would never run any thing else. but if i used a panhard it would have been only like 24-25 inches and that was way to short, it would have pulled an inch every 6 inches of suspension movement. My tires are to close to the fiber fenders for that much side pull.
Our watts links is all dom tube and tig welded just like that arms, so it carrys a lifetime warranty too, just like all our inhouse products.

If you guys have any questions feel free to call.

Thanks
Richie

when u guys goign to get into more frame builds?

we are building one for a 2001 chevy 1500 right now. There is also a frame sitting in the shop we just did for a 1993 s-10. We all have a chassis to build, some times just dont have time to post pics on all of them. We take lots of pics just hard to find time to edit them all. I will try to get a few edited this weekend so you can check them out.


watahyahknow,
i have pics of the watts link kit(as a kit on the pic table) i will try to get you those pics too.


Richie

thanks man .

the thing i was planning on my chassis is cut up a longbed chassis behnd the cab make a slant cut over 15 inch , bend a piece of sheetmetal the same thickness as the chassis intoo a piece of wiiiiiide channel to fit on the slant going bout 5 inch straight up and end in the same slant cut
lay out the front part and measure the wheelbase from the frontwheels back i want for a shortbed i cut the framerail to the propper length and weld it up again to the slant cut , this schould give a lot of weldingsurface and gives a nice finisch so the rear part of the frame will be 4 inch higher , i'm planning to run a two link out of that bended up part too .
i prolly will need to adapt the mounting for the watts on the frame , i like to see how you mount it to the axle to see if theres room left for shocks and the sorts
the floor in the bed will too and hopefully im able to lay as mush as the front and mount all the tanks and stuff under the floor , the rear part will get the same treathment for the rearbumper only shorter

nice, have to send me some pics as you get it done.

Richie

u guys finish the colorado?

Rich I wanted to say thanks for lettin me take up so much of your time this morning. It may be tomorrow night b4 I can get those measurements for ya.. That cool?

done and gone , for awhile now. It turned out good. He loved it. He drove here from wisconsin, and ended up staying the night in buena vista(saginaw), i asked him if he got any sleep with all the gun shots. When i told him about the area he stayed in, he was like "holy fuck you are kidding right" lol he didnt know any better.


Richie