6/8.5 on 1980 dually...and then some

thanks guys

Before





After





it was a good night!!!

started on the notch today got one side ready to be drill but i dont have a drill bit that big maybe by the end of the week ill have this back on the road.all that left is notch helper bags, put another wheel cylinder on the driver side then the bed , gooseneck plate and back on the road

here is the front end with all new bushing ect

I forgot to mention you also need to remove the metal stand for the bumpstop on the lower control arms or that will bottom out. If I remember it's only 3 small rivets on each that you can either drill out or grind off.

ok cool i wasnt sure about that part

what size hitch ball mount am i going to need like a 3" thats upside down?

well i got it done time for an alignment

No pics of the rear ?

for some reason the pass side front sits higher then the driver side and i do think i need to take off a 1/2 coil or so off the front spring so it sits level

you need a heavy gf for that side it will sit level then. What size tires you running ?

damn looks good