Hi everybody new here this is my project

hell ya got my parts truck today time to start pulling parts

Nice lookin start and for a good price. On the rear link though you might have some binding issue's with the end links on the diff. They are supposed to be parallel to the axle's, but you can check them throughout the full sweep. GL with the build.

if they where parallel to the axle i would need a panhard bar. this way works just fine and dont need one no binding at all.. but thanks i hope the build goes well

Not the triangulation of the bar... the two joints on the diff are at a 45* to the axle and can cause it to bind...my $.02. If the link was parallel to the axle it could be a panhard. On a side note I like the lift plate setup to view the rear

That's awesome man, your rollin along nicely. How much you pick the donor truck for?

ya i will look in to the rear more but works just fine. cut the whole front end off parts truck lots of fun. one bad thing today. 15x8 0 off set front sick , roll and pull back bad id looked dumb now have to have to fix bed. damn it....

i want to do irs so i can camber the hell out of the back! lol then the 15x8 0 off set will fit! damn i guess played with to many 240sx