New pics of my ride

I don't have one for some reason. I have 1 brake line that goes to the axle. It goes into the pass side brake then there is a line comming out to the drivers side brake. I'm puling my bed off in a little while to do my 4 link so I will take a pic.

a lot of them have some kind of taper at the bottom, but yours just looks perfect with the rest of the bed... thought maybe you did some custom work on it. hah
well anyways, good choice, looks sicko

Wow, Lookin' real tight, keep us updated along the way

Heres some pics of the 4 link fun I had yesterday. It has taken me a while to get this far because I've never done anything like this before but it's comming along good. I am going to do the upper bars today and hopefully het my shocks mounted. I am going to use my air shocks to set the ride height until I can get some bags which shouldn't be long. My axle was pushed over to the pass side by almost 1/2 inch for some reason so when I got the bottom bars welded up I took the leafs off so I could straighten it out. I just need to set the pinion angle and weld the upper bars on.

That is comming along very Well looking sharp.

looks good but your lower bars look really close to the ground

With the rear laying on the frame and the front raised up as high as my floor jack would go there is 1/4 inch between the bottom of the bar to the ground. If it turns out to be a problem I will shorten the front mounts and raise them up a bit but I think it should be fine.

Looks good man just make sure u weld those 4 link tabs up GOOD!

Welding was the easy part except laying on my back to weld the bottom brackets. Heres a pic of my welder it got the job done pretty easy. It's a millermatic 175

lemme borrow it