threads
Page 7 of 8
Mazda Projects \  Project: B5700 - Daily gone mad

Project: B5700 - Daily gone mad

Mazda Projects
views 12994
replies 77
following 36
 
bagdb2200   +1y
Thanks guys!

Jimbeater and 91extcab are both correct. It's a '94 5.7l LT1 from a 9C1 Caprice that has Corvette fuel rail covers, and a Corvette water pump.



Hey man, if you're at Lowdown this year we'll have to meet up. I didn't even know you were there last year. I was just a little too excited the whole weekend cuz it was the first time my truck was out of the garage in that state.
low_blazer   +1y
Well, trans is in, everything works the way it's supposed to so far Shot a few new pics since she was out. Hopefully now we can get final paint and body work lined up and get this bitch done

thread post photo

thread post photo

thread post photo

thread post photo

thread post photo

thread post photo

thread post photo

thread post photo

thread post photo
col. sanders   +1y
Dang and Bad Ass. The side dump exhaust is truly killer.
bagdb2200   +1y
Thanks bro! I'm stoked to finally be able to drive it. I just need to wire up the torque convertor lock-up, put a hood on it, and bolt down the seatbelts than I can drive it more than around the neighborhood. lol
hunterw   +1y
man that truck is sexy. looks way better without your ugly mug in the pic ruining it! hahahaha jk. i cant wait to see more progress on this man. i hope you make it to west coast nats.....

WEST COAST NATS......SEPT 23rd-26th!!!!!!!!!
paparoach1983   +1y

its all good i will be at this years lowdown and hopefully with my truck too. i start school tomorrow and working part time so i am not sure how much i will be getting done. more than likely i will be over by todds camp again.
bagdb2200   +1y

Cool cool. I'll try to find ya this year.
hunterw   +1y
sema would be cool too. lol./ updates?
bagdb2200   +1y

Updates? I only get to see it on the weekends. I don't have full custody. lol

I ordered the connector and stuff to wire up the lock-up so hopefully I get it by the weekend so I can wire that up this weekend. I need to go to the junk yard and grab the bolts for the seatbelts, and the buckles that go in the middle. Need to build a revised cowl hood with hood pins, and then maybe I can drive it farther than around the neighborhoods.
bagdb2200   +1y
Small update. I ordered some Centerlines for it. So I sold the Infinitis to a fellow club member. In the mean time while my Centerlines get made and shipped I borrowed his Eskies cuz the Pathfinders I had laying here didn't fit over my front brakes. lol I took a pic cuz I think they look kinda cool on the truck, even though they're just temporary.

thread post photo