B2000 Engine rebuild

Quick question.

I have a pretty bad engine vibration, I read somewhere about aftermarket mounts being to stiff and to go with factory engine mounts. I replaced mine with aftermarket and was wondering what the thoughts were.

Again, it runs like a dream but just vibrates like a sum bitch at idle and at certain rpm's.

Thanks in advance for any ideas!!

I replaced my original mounts with the aftermarket ones last year, are fine. Original ones were each broken in two.

My transmission mount is OK.

Almost forgot, I am trying to eliminate the evap canister. Any advice on what to do? At the moment I have the vent hose from the tank just tied off under the hood. What have you guys done concerning this? Or another question is if you have kept the canister what are you doing with the other hoses on the canister?

Thanks again!

I've got the Weber 32/36 DGEV on my B2200. I have left the canister in place, and just capped off any ports on it that were used by any now un-needed vacuum hoses.