What are you doing for exhaust?

So I am wondering how to go about routing my exhaust?

I am not bodydropped I am just laying frame and don't want it to get in the way of laying out!

So I am just wanting some input!

Thanks




Dev

I used to have a 2.5" Exhaust..to a Magnaflow, to a Cherrybomb, With Pipe out the side like factory, and the pipe kept getting smashed between the axle and the frame, so i took the muffler-back piece out, so now it just exits right before the axle.

i had a piece of 2" pipe bent about 15 degrees i think running off my header under the cab, and put the muffler under the cab with about 2' of pipe coming off that. yeah the muffler drags, and i've replaced it a few times, and this time plated the bottom of it so i don't have to replace it again... but hey, its a minitruck, right? and it currently has a hole in it from the driveline rubbing on it.... yeah the driveline of all things. jezus!!

i have factory style right now with a dynomax but whenever i am bagged im gona use the flex pipe shit andcut out where my notch will be and run the flex with the notch....get what im sayin?

i actualy just picked up some exaust parts thismoring... im gettin a 2.75 inch downpipe made dumping into a magnaflow cat underthe cap..the piping with then snake its way up over some crossmembers and dump through the body infront of the rear tire via. two yosimira streetbike pipes

Hey I thought you were going to let me have those pipes.hahahahahaha

no way man those are my babys i call them"THE MAKE A RICER PISS HIS PANTS PIPES"

Ya I know but put them on a real motor like the tpi I got and those little ricers would really crap a load.

i still have my factory exhaust cut off behind the cab. no muffler just the cat. it doesnt sound any different than it did with the muffler.very quiet.

Well thanks for all the replies!


Gives me an idea!



Dev