threads
Page 1 of 2
Mazda Lowering Static \  differences good and bad for fw 4 link & rv 4link

differences good and bad for fw 4 link & rv 4link

Mazda Lowering Static Mazda Suspension Mazda Tech
views 2183
replies 19
following 9
 
hayanxpocho69   +1y
what so bad about reverse 4 link, my fren has a reverse 4 link and sfbd and has had no probs.and he said u dnt have to relocate the gas tank.
so why is fwd 4 link better? what the plus and minus of both
bagged2600   +1y
controls the rear end better,stops axel wrap under braking. I feel safer,relocating the gas tank for draging anyway.I personaly have a 50/50 4 link,its never givin me any problems,but under hard braking I can kind of feel the rear try to roll forward..The reverse will work just isnt the best way to go... But I realy dont know much about much..lol
silverbody96   +1y


I'd say you did a good!!
slammeddime   +1y
If you're really up for some reading, take a poke at my paper that I wrote:
bagged2600   +1y
That was some good reading,like I said a reverse 4 link will work,just not the best way to go..
slamditbig   +1y
im doing mine 50/50 also
maztang (ryan)   +1y
i have a 50/50 with the gas tank raised 3 inches but in the stock location. i like it but i am going to relocate the tank and do a wishbone setup with bags on the bars. i hear that when you do a full reverse that it is easy to break the bar mounting brackets thus creating major problems.
gravity5   +1y
the problem with a 50 50 or a full reverse is the direction of acting forces under braking, acceleration and turning. The proper way is to do it fully forward.
bagged2600   +1y
Thats why I said that my 50/50 works,BUT I can still feel the rear trying to roll during hard braking.Forward = right way
gravity5   +1y
I have a 50 50 right now, and I hate it...I an do killer burnout,s but that only means I am not getting traction....I am redoing it with a parallel 4 witha a watts to locate the axle.