Anyone Ventured This Far-Custom A-Arm

I have been thinking a lot lately about using the combination of both these mods, but am wondering if it would be worth it?

And has anyone ever done the Custom Upper A-Arm yet?

Here is a picture of what I am talking about, keep in mind it is on a Toyota:




I assume that this would be strong enough and allow you to lay out on bigger wheels, exactly like CanDo/GrantKustoms A-Arms do!


Combine that with this:





ANd I would think you would have a GREAT setup and at a fraction of the cost!


What do you guys think!

I call it the "Poor-man's A-Arm"







Dev

i had been contemplating getting a set of some of these & see if i can get them to work.....

nytrdr those arms look like they would work the only prob I see is with the ball joints

It looks like those arms are only for SCREW-IN Ball Joints???

Nevermind there are some wiht BOLT-ON Ball Joints, it would be some work, but might be worth it!



Good find!



Devon

the thought has been crossing my mind on them also if you decide to do it let me know

^^will do,

i wish'd i had a book from the mfg's, that might be a little easier @ finding one that would fit.....will d a little more research & see what i can come up with. our top ones are bolt in too, if they made ones that had the same or close bolt up pattern one of those might work. as far as the bj's, those plates for the bolt on ones are screwed on to the adjustment arms, i'd say with a little work, you could make a plate that should bolt to our bj's....don't know though, but i thought it looked promising!

Yeah, it looks promising form a certain angle!

Good find!

Keep us all posted!

Thanks!


Devon

Hey,isnt that Seth's Yota'! I'm going to do my lowers like that.

Sure is!

I think I am going to to my uppers/lowers like that!


Hmmm.....



Dev

WE need to hassle seth and get him to make us some upper arms. that kid is TALENTED .