Drop spindles help.....

Hey everybody I just finish swapping out my stock spindles and putting in my 2 inch drop spindles. I didn't change anything else just my spindles.. And when I lower the floor jack it's not goin down like I hope it would.. Looks stock height with camber... Need help asap don't know what's up pls reply

drive it around and let things settle a bit. not sure aboot all spindles but when I put them on my old hardbody I had to do some toe-in adjustments....maybe something to watch for

It's still the same man. The upper arm is laying on where the bumpstops were

I'm assuming they're 2" drop spindles and you started with the truck at stock height....that's not a big drop for anything to bind up since you don't have the bump stops

No I had my truck dropped 4 inch blocks in back and cranked torsions down so I don't know what's wrong

is the bump stop mount interfering with the LCA? shocks not short enough? I still had to cut mine off even though I'm all torsions up front

What kine of shocks are short??? I got toxic drop on right now

I didn't flip any ball joints or have anything aftermarket just my 2in drop spindles

toxics are drop shocks so they're fine. can you get under there and take a pic?

Not at the moment. Ill try when I can. What do you think I should start doing?? Do I need lcas??? Or all stock is fine??