maz2low
+1y
With a Little Filler added .
The radiator will always be off-centered bugs me , but long story short paid close to 500.00 for the BECOOL S10 radiator after just getting it ,basically had to get it shortened/sectioned to make it work and have the bottom hose,drain,tranny lines work . What a pain
The radiator will always be off-centered bugs me , but long story short paid close to 500.00 for the BECOOL S10 radiator after just getting it ,basically had to get it shortened/sectioned to make it work and have the bottom hose,drain,tranny lines work . What a pain
Post was last edited on Jun 11, 2008 02:06. This post has been edited 2
times.
maz2low
+1y
The backside of the Filler I made ? If so I do not have any before I prepped it with Sandable body sealer , planning to blue bedliner the backside .
Are you kinda wanting to see how I made the fillers ? I made Templates for every piece of metal I cut,curved . Just explain what you need and I maybe have a picture , if not I will try my best to take one
The backside of the Filler I made ? If so I do not have any before I prepped it with Sandable body sealer , planning to blue bedliner the backside .
Are you kinda wanting to see how I made the fillers ? I made Templates for every piece of metal I cut,curved . Just explain what you need and I maybe have a picture , if not I will try my best to take one
thebeaumartin
+1y
teah the fillers i like what you have done most guys just bolt on the bumper swap and you got that gap that looks bad. i dig the fillers you have made looks rad
mazdawg(mikey)
+1y
thats gangster as hell with the ranger headlights behind the billet. the bumper looks good too. the fitment on at the fenders is top notch. that is what a yota bumper is supposed to look like on a mazda.
maz2low
+1y
Most likely I will be selling it really have no clue what to charge since it would be bodyworked already . Right now I have the extra one plus this one that is not fender matched (Picture Below). So I have 2 extras lol . I have alot of templates that I may upload to show step by step what is needed to be done it is quite easy just need patience getting it flush and tack welding . This can all be done with a Welder,Shears,Snips .Body Dollies/Hammers would help , but not needed . The one above in filler I sectioned in the middle to make the angle match the Fenders a little better
Most likely I will be selling it really have no clue what to charge since it would be bodyworked already . Right now I have the extra one plus this one that is not fender matched (Picture Below). So I have 2 extras lol . I have alot of templates that I may upload to show step by step what is needed to be done it is quite easy just need patience getting it flush and tack welding . This can all be done with a Welder,Shears,Snips .Body Dollies/Hammers would help , but not needed . The one above in filler I sectioned in the middle to make the angle match the Fenders a little better
maz2low
+1y
thanks for all the compliments on the bumper . Will post more pictures once I get around to priming it and repainting hood,grille and bumper