mazda mpv power windows?

ok...pretty sure i've got it, didnt finish install just yet since i couldnt/ got frustrated trying to figure out some power window switch setups, but i just leaned the top of the regulator twards the front of the truck a couple of mm's or so and it lookd to work a little bit better, if anyone can help out with the 5wire switch setup let me know but i think im going to get these and call it a day
" target="_blank
or this one

If I remember correctly, when I switched to power windows on my Civic and decided not to bother with huning down and swapping all the harness crap I just picked up two single pole double throw switches from my local Radio Shack.

I'm ready to see it in action!

This was a pretty good idea brother! lots of donor vehicles in the JY for parts

I pulled a mpv regulator out at the salvage yard today to check it out and I noticed that the top mounting bracket on the mpv is not as tall as the truck one. So if you are still having problems I would say put a few washers under it to push the top of the reg towards the out side of the door and it should work better. I thing I'm going to go back next weekend and buy both of them for my truck. I'll probably take the brackets off the truck reg and weld them to the mpv regulators so they fit better.

actually i measured them against eachother and i had to cut the top of the mpv reg about 2" so i could be able to snake it in, also in the 2nd pic twards the bottom of the pic i had drilled a hole just to the left of the factory mount hole to line up the reg for height to kinda line up with the top mount holes because the distance between mount points is roughly the same

ThaFox did you ever get this problem resolved?

Bolt in power windows on my 87 Mazda B2000. Here is a video:

Hey tuna, did you use the MPV components or another aftermarket kit?

Seems like it works perfect Tuna. Is that the Electric Life kit?