89 b2200 Project Truck *backhalf pg8*

yeah man nice job seen the lower bag mounts in one of the pix are those the SD mounts

yeah im usein the kit from there super lift super pivot 4 link

what size is that notch

i went over board on the notch i bought a bridge kit a while back from SD


its a 10"

LOL


Peace N|ck

looking good bro. what size is the 4 link tubing? and i am going to ask a stupid question cause i really don't know. i have noticed that not many people use a panhard bar anymore...why is this? my 83 has a 50/50 4 link and no panhard bar. i didn't bag my 83 but i will be redoing it with a wishbone with bags on the bars when i do redo it. just wondering.

lookin good 90b2200, quick question, one of the pics the top link bars have the adjusters on the axle end, and in the two below, the adjusters are on the x-member end? what up wit that?

maz,
if i understand it correctly, with a triangulated 4-link or a wishbone link setup, you don't have to run a panhard, or watts link, cause the triangulated links or wishbone keep the axle centered & don't allow any side to side movement....

Triangulated 4 links dive enough lateral support to not need the panhard bar. parralell 4 links provide little if any lateral support so a panhard bar is required.

cool thanks guys, now i know.

heck, i was under the same impression until a couple weeks ago, & someone said about the same thing when i asked about it...

yeah i didnt flip the bottom bars around yet....

i had to move the top ones round cuz it waz binding