My dawg

Well I finally got some work done on my mazda here's the rear almost done.



The pathfinder rearend fits perfectly and it's exactly the same size as the 4x4 rearend.

looking good. just one question for you though. may be a stupid question but it looks like the cross member where the front of the 4 link mounts is higher than the bed mounts. are you cutting that out too or does it clear the bed of the floor? i like it cause it is different.

about time you stopped bein lazy and got to work on your mazda lol hahaha

the crossmember is like 1/8 to 1/4 under the bed but yes I am raising the bed. I am going to be 18 gauging the whloe thing so it will look like a bathtub and even putting a drain in so I can fill it with ice and my spiecial drinks.

You flux?

No I used my arch welder on the axle and my mig on everything else and it has gas.

very noice, looks good man. what size rims are you settin up for?

I will be running 20" or 22" depends on my friend and what he can do for me.

Lookin tight man...

i never seen those notches on anyones truck before they're different and i think they look great.