threads
Page 15 of 17
Mazda Projects \  1991 mazda b302 UPDATE 4/11 !!!!!!!!!!!!!!!bags

1991 mazda b302 UPDATE 4/11 !!!!!!!!!!!!!!!bags

Mazda Projects
views 17162
replies 160
following 40
 
paparoach1983   +1y
okay here is how you last saw her
thread post photo

here is where she is at now lol.
thread post photo

still left to do
locate rad
wrap all wiring in the green black loom
thread post photo

lockar accelerator cable and kickdown cable
thread post photo

thread post photo

finish bag brackets for these
thread post photo

put this in
thread post photo

put all this back in with stock mazda cluster
thread post photo

and some after market gauges
( no pic )
Finish plating the whole, and around the whole lower plate, and add upper bag bracket, clean where the old stabilizer bar was and instal a newer lower one, and then finish the front frame clip in por15 as well as put a stock rad support for a mazda back in.with ranger headlights and billet grill
toddluck   +1y
nice man hope its at lowdown this year
paparoach1983   +1y
it will be
baggedbmy93mazda   +1y
its coming together man...nice bit of progress..keep it up..
skrapinsask   +1y
That ranger front end is not my style at all but i gotta say im feelin it!
paparoach1983   +1y
i gotta figure some things out with it cuz its too wide so i will rock a mazda front for a little bit longer.
dropem1991   +1y
Hey man i am n the middle of doin the 5.0 swap in my bagged b i was wonderin did u use the mustang motor mounts and what did u do with the tranny mounts i made ne tranny cross member and carrier bearing crossmember so the duals can fit and are u doin a 2 piece shaft or one thanx for ne info
paparoach1983   +1y
One piece shaft, made my own motor mounts, modded a new tranny mount for the ford to work with the mazda tranny tunnel, wich will be replaced soon with a modded ranger with dual exhaust ports thru it
crush   +1y


Lookin good so far bro. so are you going to have it driveable by the time of lowdown, or are you going to trailer it in? Hopefully those Beefy engine mounts you made will hold up.
paparoach1983   +1y
haha they should its plated all around. and i should be driving it for lowdown. i will have the front bagged and laying frame but not the rear. i dont believe in bagging it with monoleaf. I am also hoping i will have enough time to atleast get it into one color of primer by then too.


also i have found someone to trade my 2wd fenders and a different bed for 4x4 sheetmetal. so i will have another bed to cut down lol.