Mazda 4 Door Longbed on 20's

Not much done, been waiting on ends to triangulate the LCA. Mounted the wheels to see how much lift. Just thought I would post pics. So onto the pics, its only two by the way.

ONLY 90 PSI


ALL THE WAY DOWN

gunna be one sick truck!!

WOW!! I haven't tocuhed this thing in a while. Anyway did get something done but not much. Made my tubes to triangulate my LCA.

This thing is turning out sick. Keep it up man!

Updates?

Just the pic above. Haven't had any time to work on it.

lookin good man!!!

Well holy cow I haven't touched this thing in quite some time. Finally got out of the white tent and into the oversized shed(garage....LOL). Decided to use different ends for my LCA. An I have a set of cross shafts to make my new UCA in the near future. Well on to a couple pics not much thought. But hopefully soon more progress will be made....keep you fingers crossed for me. Sorry cell phone pics forgot the camera.

hells ya man i did that to mine, you lay lower that way, i put 1/2" metal as a cross member and cut off rest to make it lay flat...had to cut some of the arm off to but it ok there still a good amount left of it, but i would do a z next time

wow chuck bout time ya got back into the project, lol
like I m one to talk,
we started about the same time and we're both baggin with 20s
lovin the LCA, keep going,
I had hooooorribly rusted inner wells where the cab is laminated out of several layers of sheetmetal, i am rebuilding the floor and fender wells smoothing the firewall all at the same time, check out my build thread tubbin n dubbin

I wish I had notched the frame a little , right now I am debating a Z and narrowing the frame
I also gotta balance out my camber and try get some steering radius back too.

Gotta tweak my front end set up , oh I am using the re-6s too, we should compare notes some time.
I got a tube bender etc too , I also have ben contemplating building UCAs