1990 Mazda B2200 Is BodyDropped!!!

I love the Hoffman Group, and have used many "Keep It Clean" products but never a whole harness. For a harness, in my opinion there's only one, "Painless". It's what they do, and they do it so well. Painless is priced just a little higher so budget wise I don't think that you will have any problem with the "Keep It Clean" system.

ya i saw that a while ago couldnt find it today i just want to confirm that it will work , do i need my stock fuse panels and so on ?

Ok, looked into the "Keep It Clean". It doesn't really get specific in what the kit has but I would do the 13 Circuit. It has the fuse panel and an ignition harness (does not say to what but probably a GM). I will be talking to them in the next few days and I will ask.

Here is the Painless that you would need:



This kit has everything that you need for a carb'd system. It's about $100 more than the "Keep It Clean" but I have used this harness many times before and it is amazing, easy with NO headache's. Everything is labeled and it is complete with even the fuses and connectors.

With any of these kits you will need the following tools and supplies:

Soldering Iron (Weller's are amazing)
Good strippers
Multimeter (even a cheap $10 one will be fine for one of these systems)
Shrink Wrap (Various sizes)
Wire Loom (Painless wire loom is really good, wire loom everything, even under the dash, cleaner install and there will be no chance anything will be knicked or pulled)
Solder
Electrical tape
Zip Ties (All sizes, black)
Note book to document any changes you make (makes repairs or changes later way easier)

Now I want to do a wiring system. I love to do wiring, weird but to me it's relaxing.

nice !! i will probably order it once my frame is done ,in the meanwhile ill be doing my floors and the wiring
but my only concern is i have a fuel injected engine will it work ??? and also are these universal or just for gms
cuz oviously i got a b2200

Yeah most every harness from keepitclean is for the gm colums

Did some work today:





Theres My English Mastiff Also ^^:)

Hopefully my mom will drive me to canadian tire to get a 14mm impact socket , my deep socket wont fit between the frame and cab floor also ran out of grinding wheels then ill pull the frame out

So i made it out to canadian tire got some grinding disks ,the impact socket i needed

More photos:




And thanks to mazdaman82 i got this today :


Bags should arrive sometime next week then that will be it for a little bit
next plans are to order the steel tubing (2X3X1/4") and start the back half of the new frame
in approximately 1 week

nice

hells ya you got it... damn it looks better in your pic then it did in my floor...lol

lmao ,thanks alot man i love it