threads
Page 1 of 2
Mazda 2.2L \  which wire goes to the oil pressure switch?

which wire goes to the oil pressure switch?

Mazda 2.2L Mazda Engine Mazda Tech
views 1909
replies 17
following 3
 
saveacivic   +1y
I know it's a single wire and I see the oil pressure switch... But there are 2 single wires not connected in my engine bay right next to the oil pressure switch...
nc4life   +1y
Just looked at mine, it's yellow with a red stripe. Hope that helps
saveacivic   +1y
ok i'll look for it. thanks!
saveacivic   +1y
found a single yellow wire with a red switch but it is pluggrd into an egr-looking thing near the carb inlet (took off the carb housing too see it)... is it plugged into the wrong place? perfectly possible; last oener just slapped this thing together,,, thanks!

I'm going to take pics tomorrow, i have the motor taken apart doing the rebuild...
nc4life   +1y
I remember somewhere someone saying the a red wire goes to the egr valve.
saveacivic   +1y
to the egr yes.. but if you are looking at the egr from the front of the truck; it's a little towards the firewall but looks like the egr valve... no idea what it is..
nc4life   +1y
The egr valve is on the side of the intake under the carb.
saveacivic   +1y
just took some pics have to load them.. so we know what I'm talking about here...
saveacivic   +1y
Is it this wire? It's the only loose wire left in the engine bay... It's a little bit thicker of a wire, but is Grey with a Yellow stripe and comes out of the main wire harness right above the oil pressure switch. The wire was cut so ???


nc4life   +1y
That looks to be your 02 sensor wire.