oil sending unit????

ok its yellow with a red stripe..uploading pic

ah ok got ya.... thats the extra wire i had i thought was for the electric choke.....

glad i could help man

Glad you got this sorted out . .

For future reference. . .

Had you kind of swung the loose wire around (from your deleted pic), you would have seen an arc that would have only intersected points within the arc.

I think you would have found that the pressure sensor was one of those points.

Additionally, if you have dropped the choke heater wire down to the wire you were asking about, you would have found that the two plugs would not connect to each other.

thanks for the info but for some reason the wire isn't long enough with the way that harness ended up being if you notice in the picture i had to swing the clamp down instead of the original up position... i think this is due to my ground wire location now.... i put it on one of the starter bolts on the back side of the bell housing... which made my harness a little to short.