Page 1 of 3
Mazda Engine General \ Magnum Valve cover ?Magnum Valve cover ?
views 7930
replies 28
following 13
ledevil
+1y
So I was at the junk yard today getting some random parts when I found a valve cover on a 87 Mazda B2200 that had the word Magnum stamped on it. It was factory looking and the only one I've ever seen. Any info on this? By the way I did buy it so I will post pics tomorrow or when ever I get new battery's.
pont
+1y
I would go back and get the hole motor just in case it is a true Magnum motor. there supposed to have more power then the reg 2.2.
nytrdr24
+1y
look something like mine?
mazda produced a few in 86-87, they were only sold in japan in the 626 i believe, but have heard some made it to austrailia...slightly higher compression than our trucks 8.6:1, rumored in the 9.?:1 area with larger valves. there is a little info on this link, scroll down till you get to the FET engine
to answer your q of how to tell, pull the head, if it has dome top pistons it's a magnum, more than likely it's only the valve cover...
mazda produced a few in 86-87, they were only sold in japan in the 626 i believe, but have heard some made it to austrailia...slightly higher compression than our trucks 8.6:1, rumored in the 9.?:1 area with larger valves. there is a little info on this link, scroll down till you get to the FET engine
to answer your q of how to tell, pull the head, if it has dome top pistons it's a magnum, more than likely it's only the valve cover...
Post was last edited on Jul 31, 2008 03:07. This post has been edited 1
times.
marco
+1y
too much confusion in this thread....
anyone care to explain more about this "magnum" motor?
"edit" -- i literally posted second after the post above...thanks for the explanation
anyone care to explain more about this "magnum" motor?
"edit" -- i literally posted second after the post above...thanks for the explanation