bye bye door handles...

Mazda Projects

replies 15

following 8

toddluck +1y

lookin good man

bagged2.2 +1y

how the heck can i round corners? lol. i used a 4 inch cut off wheel. and thanks, hope to have the doors primed this week

charlesskelter +1y

Measure out the area and mark all four corners, drill the corners out (inside of all your marks) first then cut with the 4 inch cut off wheel.

bagged2.2 +1y

lmao. nigga please . thats a waste of time. and these doors are so thin who wants to be pushin on them with a drill. haha

charlesskelter +1y

The only "nigga" here is the person so ignorant to use the term.

bagged2.2 +1y

haha. cool down there fella. dont pull the race card. it was a joke.

Page 2 of 2