Drivers side lean

Hello All,

I know I have asked some of you about this in PM's, but I am just trying to get a broad base fo opinions so I can fix this ASAP. In redoing my bag setup, we installed a KP 6 link and ART UCA/LCA Coolride setup on my 2000 Silverado. When aired up however, it seems to lean on the Drivers side 1/2 to 1 inch. This did not occur on my old setup (Belletch spindles and cups on factory control arms)

I am thinking the problem is occuring in the rear, since when I let the rear all the way down, it seems to even out. I have only 2 switches (Front/Back) and I have 8 valves (one fill and one dump per bag).

We havent tightened down the KP rear yet, since we are still trying to set pinion angle and get the axle all aligned and the front has not been aligned either.

Can you guys think of some reasons that this may be happening so we can start troubleshooting this so I can get my truck back on the road?

Thanks Chad